From: billy_at_mix.com
Date: Mon Jun 26 1995 - 15:02:23 EDT
Simon Maufe<snmauf_at_elm.monsanto.com> writes -
> When I connect using my new 755 and the DSP modem, it says
> 'connect 14400/ECLC' and performance is like a teletypewriter.
Be sure your comm port setting on the software talking to the MWave modem
is set to 38.4k or 57.6k (what I use). After that, at least for now, you
are pretty much stuck with the relatively large latency in getting data
through the MWave modem (about 600ms round trip time vs. less than half
that for other modems I've tried). This may get better when the 28.8
software for it is released. That is (depending on who you ask) anywhere
>from within a few days to a couple months away.
As for AT commands, all I did was make mine hang up when DTR is dropped,
otherwise the defaults are ok, at lesst for me. There is nothing to tweak
(that I could find) for the above type of situation.
Billy Y..
This archive was generated by hypermail 2.1.3 : Thu Jan 23 2003 - 09:52:39 EST