Re: [Thinkpad] New 40G HDD on TP760XD using DM2000

isolate pin 59 or 60, either of the last two .
do it by unsoldering that socket/ pin of the flexible plastic wiring
harness that goes from the caddy conector to the HD connector .
the hole is quite a bit bigger than the pin of the socket connector so just
unsolder it.
then clean the area around the pin with a X-acto knife.

this is much better than playing with the pins of the HD .

...peter..

----- Original Message -----
From: "Kevin Koehler" <klkoehler@hotmail.com>
To: <thinkpad@stderr.org>
Sent: Friday, April 04, 2003 9:31 AM
Subject: RE: [Thinkpad] New 40G HDD on TP760XD using DM2000

> So if I modify the drive select wires will the drive also still work in
the
> ultra bay? What pin numbers are modified (57-60?), or can I short/ jumper
> the drive pins together on the drive before I attach the caddy cable
> connector, what would happen if I bent the hdd pins down- would it make
the
> drive useless anywhere else?
> _______________________________________________
> Thinkpad mailing list
> Thinkpad@stderr.org
> http://stderr.org/cgi-bin/mailman/listinfo/thinkpad
>
>

_______________________________________________
Thinkpad mailing list
Thinkpad@stderr.org
http://stderr.org/cgi-bin/mailman/listinfo/thinkpad
Received on Fri Apr 4 12:50:58 2003