[Thinkpad] TP 600E Configuration Utility

Problems, problems . . .

My HD crashed, so I used the recovery disk on the warranty HD I
received. However the Configuration Utility fails. If I click
on Thinkpad from the Program menu, and select Configuration,
a small splash screen appears for about 2 seconds, then exits
silently. The same occurs if I run the file TP98.EXE from a
command prompt.

I then tried to install the latest and greatest 600E Configuration
Utility UTTPCW32.EXE (d/l from IBM site) but this fails on exit
with error "program UTTPCW32.EXE performed an illegal operation;
Contact vendor"

The diagnostic details:

 UTTPCW32 caused an invalid page fault in
module <unknown> at 0000:30303032.
Registers:
EAX=00000000 CS=0177 EIP=30303032 EFLGS=00010282
EBX=00570000 SS=017f ESP=0067fda0 EBP=2f654d2f
ECX=80006ac8 DS=017f ESI=00000000 FS=221f
EDX=80006a30 ES=017f EDI=00000000 GS=0000
Bytes at CS:EIP:

Stack dump:
0950582f 00000043 00000001 00000010 004089c5 00400000 00000000 81728b33
00000001 00000000 8173891c 00570000 c0000005 81728b33 bffc9490 00000044

I'd appreciate help to get either of these working because I cannot
configure the hardware without the utility.

Jeffrey Race

_______________________________________________
Thinkpad mailing list
Thinkpad@stderr.org
http://stderr.org/cgi-bin/mailman/listinfo/thinkpad
Received on Wed May 28 13:16:50 2003